JANUARY 20229MANUFACTURING TECHNOLOGY INSIGHTSPSE devices have a signature process while powering up to protect incompatible devices from damage when they are connected. This involves first checking the signature resistance of the PDthe PD receives the power and uses it (load). PSE devices have a signature process while powering up to protect incompatible devices from damage when they are connected. This involves first checking the signature resistance of the PD. The PD will only be supplied with power if this value is correct (25k). If the PSE detects a PD, it starts with the classification; that is, with the determination of the power requirements of the connected device. For this, the PSE applies a defined voltage and measures the resulting current. The PD is assigned to a power class on the basis of the current level. The full voltage and current will be supplied if everything is correct. As soon as the PD is supplied, it has the task of converting the PoE voltage of ­48 V to a supply voltage suitable for the terminal devices. In typical PD designs, an additional dc-to-dc converter (diode bridge controller) is used. It has the task of adjusting or covering the power requirements of the components supplied by the PD. Newer ICs already offer the possibility of integrating the interface and the dc-to-dc converter into a single component for low power classes, which simplifies the design.Because PDs must accept a dc operating voltage of any polarity over their Ethernet inputs according to the IEEE802.3 PoE specifications, two diode bridges are required in front of the inputs of the PD. Thus, the PD also works with reverse polarity, regardless of the wire pair used. Figure 2 shows an LTPoE++-, PoE+-, and PoE- compliant PD controller with an integrated isolated switching regulator. A controller like the LT4276 enables operation for both forward and flyback topologies, as well as synchronously for power classes from 2 W to 90 W. Conventional PD controllers of lower power classes have integrated power MOSFETs, but at higher power the option of driving an external MOSFET enables the PD to decrease its losses and increase its efficiency.Because the IEEE802.3 Ethernet specifications require electrical isolation from the ground connection of the device housing, the system needs an isolated controller chipset for the PSE. A digital interface (LTC4271in Figure 2) connects to the PSE host on the non isolated side while an Ethernet interface (LTC4290in Figure 2) connects on the isolated side. The two components are connected by means of a simple Ethernet transmitter. Through this robust PSE chip set design, additional components for generating the isolated power supply can be avoided.An increase in the power and efficiency of the overall PoE system can be achieved if the two diodes of the full-bridge rectifier on the PD side are replaced by ideal diodes. Therefore, MOSFETs are used and controlled such that they act like typical diodes. Through this, the forward voltage can be drastically lowered due to the low channel resistance [RDS (ON)]. An ideal diode bridge controller in combination with the PD controller manages four MOSFETs in a full-bridge configuration (Figure3).Figure 2. Example of a PoE circuit.Figure 3. Conventional diode rectification vs. driving via a diode bridge controller.PoE and standards developed in parallel such as LTPoE++ to connect smart factories and buildings while providing a robust, end-to-end, high power approach to simplify the design and implementation of power supplies.
< Page 8 | Page 10 >